|
For repairs on Oaks commercial water heaters, just contact Hong Kong Junhong Electrical Appliances for repairs!For repairs on Oaks commercial water heaters, just contact Hong Kong Junhong Electrical Appliances for repairs!
Commercial water heaters often have a higher probability of failure due to their high usage rate. Especially some of the more famous brands of commercial water heaters, such as Oaks water heaters, etc., although they are of excellent quality, they will inevitably encounter some common faults. Recently, Junhong Electrical Repair in Hong Kong happened to encounter the repair of Oaks commercial hot water heaters. furnace case, so I take the opportunity to talk about common water heater problems and their solutions.
1. After turning on the water heater, the data on the display panel is incomplete.
1. Insufficient data display on the display panel is often caused by damage to the control panel in the water heater. Therefore, the digital tube is damaged. Directly check whether the chip on the display board is damaged and whether there is a partial open circuit in the circuit. You can directly replace the digital tube, chip and display board of the corresponding model of the display board. Of course, this is within the scope of major repairs, so you need to find a professional team like Hong Kong Junhong Electrical Repair to handle it, rather than doing it yourself.
2. Low water pressure or insufficient water flow may also be the cause of abnormal data on the display panel. It is necessary to check whether the connection of the magnetic control board is intact and whether the leads are plugged in normally. And the related components that control water pressure and water flow can also be changed.
2. Solutions to water leakage problems in water heaters
1. Water leakage may be caused by damage to the sealing ring or bursting of the electric heating film tube. When the master comes to your home, he will usually check these two areas, and finally replace the sealing ring or electric heating film tube. Hong Kong Junhong Electrical Maintenance will usually look for matching brand accessories for replacement.
2. The water pressure is too high and the internal parts of the pressure relief valve are faulty. You can disassemble the pressure relief valve to see if there is a problem with the internal spring or some major accessories. This is a more professional maintenance mode, so it is recommended that professionals come to conduct inspection and replacement.
3. The outlet water temperature is too high or too low, and is different from the displayed temperature value.
If the temperature and value do not match, it is most likely caused by poor contact in the sensor wire, or it may be caused by an open circuit or short circuit in the resistor. Once the sensor encounters a problem, the master will often match the corresponding accessories that need to be replaced and come to the door to deal with it in time. Users must not check blindly to prevent leakage.
The above are answers to the problems encountered in repairing Oaks commercial water heaters. Commercial water heaters often have large capacities, high power, and complex environments, so they can easily cause circuit failures. You must find a professional maintenance team to handle them. . |